Autoglym Polar Kit

The Autoglym Polar Kit contains 3 products used via a pressure washer to maintain & protect your vehicle.

Polar Blast is used as a pre wash snow foam and produces a highly dense foam blanket to your vehicle to help maximise cling time and loosen dirt.

Polar Wash is a safe and effective cleaner applied after using Polar Blast to remove excess dirt, traffic film and grime from your paintwork.

Polar Seal is a very protective coating that has been specially formulated for application through a pressure washer with a foam gun. It imparts a hydrophobic layer onto paintwork that causes water to bead on the surface which reduces the time it takes to dry the vehicle. Simply spray onto a clean, wet surface, rinse off and dry to leave behind a durable, high gloss finish.

• Contains Polar Blast, Polar Wash and Polar Seal products
• Leaves a durable, high gloss finish
• Specially formulated for use with pressure washers

Polar Blast:

• Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
• Polar Blast can be used at various dilutions depending on the density of foam desired. A good starting point is 100ml product to 500ml water in your foaming bottle. Adjust foam gun settings as required to increase or reduce foam.
• Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels.
• Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it to dry on.
• Finally, rinse thoroughly from the bottom up.

  Polar Wash:

• Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
• We recommend a pre-wash with Polar Blast to gently loosen dirt. If not, rinse first with water to loosen heavy contamination.
• Polar Wash can be used at various dilutions depending on the density of foam desired. However, we would not recommend using a dilution stronger than 50:50. Adjust foam gun settings as required to increase or reduce foam. 250ml of mixed solution should be enough to cover an average sized car.
• Spray Polar Wash onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels.
• The cleaner will begin to loosen dirt on all surfaces. For the most thorough clean we recommend agitating the foam with a sponge or wash mitt.
• Rinse thoroughly from the bottom up and dry.
• Polar Wash is not suitable for use on soft top convertibles.

  Polar Seal:

• Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
• We recommend starting with a snow foam like Polar Blast to gently loosen dirt, and follow with Polar Wash to remove any dirt or contamination on your paintwork.
• Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the finish.
• Spray Polar Seal onto the clean, wet vehicle, ensuring all exterior surfaces are covered, although avoid direct application to the windscreen.
• Thoroughly rinse and dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a cloth and not allowed to air dry as water spotting may occur.
• Use Autoglym Fast Glass to clean the windscreen and wiper blades to ensure no smearing occurs.

  Click here to find out more about the Autoglym range