Autoglym Polar Wash

Polar Wash is not suitable for use on soft top convertibles

  1. Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight
  2. We recommend a pre-wash with Polar Blast to gently loosen dirt. If not, rinse first with water to loosen heavy contamination
  3. Polar Wash can be used at various dilutions depending on the density of foam desired. However, we would not recommend using a dilution stronger than 50:50. Adjust foam gun settings as required to increase or reduce foam. 250ml of mixed solution should be enough to cover an average sized car
  4. Spray Polar Wash onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels
  5. The cleaner will begin to loosen dirt on all surfaces. For the most thorough clean we recommend agitating the foam with a sponge or wash mitt
  6. Rinse thoroughly from the bottom up and dry

    7. Top Tip – Follow with Polar Seal for a protective, hydrophobic coating